Electronic wheel pick-up

€1,198.00
Tax included

The electronic wheel pickup is used to generate pulses for electromechanical odometers (e.g. all Prestel+Gemmer devices,...) and electronic odometers as well as our electronic drives (Rally-Gear, Rally-Drive GT and Rally Drive Speed) directly from a non-driven wheel.

This avoids deviation of the distance displayed on the odometer caused by slippage, especially on loose and/or slippery surfaces (e.g. gravel, snow, ice,...)

The wheel pick-up is sealed against splash water and penetration of dirt and is therefore suitable for use in rough conditions.

The wheel pick-up is equipped with 2 independent sensors and is therefore suitable for controlling 2 devices.

Quantity

 

Privacy policy

 

Delivery

The electronic wheel collector is mounted on the rim or wheel hub of a non-driven wheel by means of an adapter flange.

The adapter flange is permanently connected to the rim or wheel hub. The wheel collector is attached to the adapter flange with a central fixing screw.

If the wheel collector is not needed, it can be removed by loosening the central fixing screw. The adapter flange remains on the rim or wheel hub.

The interface between adapter flange and wheel collector is closed by a protective cap when the wheel collector is removed.

To ensure the tightness of the wheel collector, the central fixing screw is located under an additional screw plug.

The adapter flange must be individually adapted to the rim or wheel hub (central locking nut is also possible). Therefore it is necessary that you send us the rim and / or wheel hub. The wheel pick-up delivers 6 pulses per revolution with 2 independent sensors.

The supply voltage is 5-24V. The cables are routed in a plastic tube and protected against the penetration of dirt and moisture and damage.

The maximum cable length is 1.8m. The connection is made via a 6-pin screwable plug.

Specific References

You might also like