Odometer

Mechanical tripmeters:

General information:

Mechanical tripmeters are generally maintenance-free and should be checked by a specialist approximately every 2 years.
If there are incorrect readings or jerky movements of the number rollers, do not try to make the tripmeter functional again with excessive amounts of oil or grease. Mechanical defects cannot be repaired this way.
Read the operating instructions for the devices and avoid operating errors.
When changing gears, ensure good, but not too tight, engagement and turn the gearbox before installing it in the device to check for smooth operation.

Stalling or jerky movements of the HALDA counter are usually due to wear of the gear on the 10s roller. This should then be replaced.
In classic cars with the original speedometer cable, it can also be due to material fatigue of the speedometer cable core. This twists in on itself and should be replaced.

Special considerations for HALDA Twinmaster devices:


The Twinmaster with an aluminum housing is not equipped with 2 side adjusters, like the newer HALDA Twinmasters in plastic housings, but only with one. Aluminum housing > 1 adjuster, plastic housing > 2 adjusters.
To avoid damaging the device and the drive, switch the forward/0/reverse knob on both devices to 0.
For the HALDA in the aluminum version with only 1 side reset button, also set the drive knob on the bottom right to the lower drive (turn to the left). This relieves the entire drive for adjustment and prevents damage. 

Electronic / Semi-electronic tripmeters:

General information:

Electronic and semi-electronic tripmeters are susceptible to incorrect readings or failures due to voltage fluctuations and interference fields in the vehicle.

The following points should be observed during installation:


The pick-up sensor should not be mounted directly near magnetic fields or electrical systems.
These tripmeters should, if possible, be connected directly to the battery.
An intermediate voltage stabilizer is also helpful.
The car's ignition should be radio-suppressed.
If the connecting cables between the sensor and the tripmeter need to be extended, use cables with the same cross-section and resistance and ensure a good connection (preferably soldered).
Only if all these criteria are met will these devices provide a reliable display.